| George Knives |
 |  |  |  |  |
 |  |  |
| Building a Sub-hilt fighter |
| © Copyright 2007 George Knives |
| Page 3 |
| Thanks for checking it out, hope it was entertaining! |
| Bolsters are peened down and good to go. The shifted a little in the peening process, but I left enough material that I can grind everything back into alignment. |
| Setting up the insets and the scales to fit into the dovetailed bolsters. |
| Gluing the scales on |
| The extra glue is all ground off and it's time to put some contour to it |
| I get about 99% of the work is done on the grinder, then I finish blending out the lines by hand. |
| Finishing things up with sharpening the blade, you can see the wire edge in the first two pics. That pretty much finishes things up for this one! |
